ShortScale.org

I have been wanting to learn about 3-D printing for a while and my work has a number of them.

I found a free model of old Sovtek Big Muff knobs and trying to get them to actually work.

I broke the first two drilling them out, but I was able to insert an brass piece with a set screw in the third one.

I attached it to a pot to make sure it would work.

The new ones we printed on a better printer and look a lot better.

I hopefully will have some fully functional ones available soon.

Untitled by Joey, on Flickr

Untitled by Joey, on Flickr

Untitled by Joey, on Flickr

Well done!

NickS wrote: ↑Wed Mar 02, 2022 7:32 amWell done!

Thanks. The working one is cracked on the top. I am hoping refine the process and make the next ones without breaking the knob.

what a great use for 3D printing, too.